HomeOrderProduct Design / Help

Primary Parts:

  • Laser cut parts
  • Airsoft Gun
  • PicoSwitch
  • Pololu Serial->Servo
  • Entire list: gun_parts.xls

    • The total cost for the parts is about $200.

    Part A

    Servo and Gear mount: The servo mounts in the center hole, and the pan or tilt shaft goes through the big hole.
  • gun_a.gif :: gun_a.dwg (Autocad 2007)

    • Part B

    Base of the Pan section: The nuts go through the square holes, the many holes in the center are the various mounting points for the pan assembly.
  • gun_b.gif :: gun_b.dwg (Autocad 2007)

    • Part C

    Feet: The legs of the entire assembly
  • gun_c.gif :: gun_c.dwg (Autocad 2007)

    • Part D

    Connector to Gun: The center hole is for the shaft, the rest are optional mounting holes
  • gun_d.gif :: gun_d.dwg (Autocad 2007)

    • Part E

    Circuit and Tilt support: The pololu, picoswitch and safety switch attach here, as well as a support for the Tilt shaft
  • gun_e.gif :: gun_e.dwg (Autocad 2007)

    • Part F

    Pan shaft support: Lower support for the Pan shaft
  • gun_f.gif :: gun_f.dwg (Autocad 2007)

    • Part G

    Camera mount: Extension off the gun that the camera can attach to
  • gun_g.gif :: gun_g.dwg (Autocad 2007)

    • Parts Pictures





    For general inquiries, contact support@robotairsoft.com